The P-2 replaced the O-11 in the Air Force inventory as the service's front-line combat aircraft crash vehicle. Known in the Air Force as the P-2 or 'Rolling Tetnus Shot' due to the large amount of rust they accumulated. Those who drove or rode in her loved what this slow but powerful beast could do. Have your choice of Air Force Badges on the front.

The P-2 FWD 8x8 Crash truck was part of the third-generation of crash trucks along with the P-4 Oshkosh crash trucks. The P-2's were built by FWD beginning in 1962, and delivered by the end of 1962, each P-2  had two turrets, two six-cylinder gasoline Continental Engines, a 1,400-gpm pump, a 2,300-gallon water tank, and a 200-gallon foam tank. In 1981, Quality was awarded a contract to rebuild and repower (Diesel) the fleet of P-2's.  The remanufactured P-2s had two V-8 Detroit diesel engines and produced an enormous amount of torque and acceleration. On a few occasions, the power was able to twist the drive shaft. This was the introduction of diesel engines for crash trucks, one improvement long overdue. In fact it was stated that the truck had too much speed to stop with the original brakes.

When Quality rebuilt the P-2's with diesel engines, they were renumbered as P-2As. The engines were not the only changes made to the P-2’s. The original FWD P-2 had roof turrets that could put out 1,000gpm, and a hand-operated bumper turret that put out 300gpm. The P-2As had turrets that were basically cut in half. The original turrets had two foam, and two water barrels, Compared to the original, the roof turret had only one foam barrel. The bumper turret was replaced with one that was electronically-operated. The trucks were also changed from painted red to yellow.

The P-2s had seating for four firefighters, including the driver-operator, who often was the only crewmember aboard during emergencies. The Driver also had to operate the turrets. The right seat was said to be for either a turret operator or a crew chief. There was a seat on either side of each of the trucks, just inside the folding doors, and up the steps on the deck, and facing forward, not facing the doors. The P-2 was considered to be a great crash truck

.

Like us on facebook and keep up to date on all new designs.

Front Image is 4"and is your choice of USAF Fire Protection Badges.

Rear Image is about 14" x 16"

In most cases some maybe smaller or larger dependant on the logo

Gildan 6.1 oz. Ultra Cotton® T-Shirt

Thank you for visiting Badges of Honor. We are owned and operated by firefighters. We sell Firefighter, Law Enforcement, EMS and Military Clothing. The majority of our  apparel are NOT screen printed as we use a direct to garment printing (DTG) process. This will ensure that the art will not crack and/or peel off. Direct to garment printing has become popular because it is almost 100% eco-friendly. While screen printing and other methods often use synthetic plastisol-based inks, DTG printers use environmentally-friendly, water-based inks, with the exception of certain mild solvent based and discharge inks used on a small percentage of printers.  DTG printing simply requires the image to be of adequate resolution and it can print a full color image directly onto the garment. Our T-shirts are of high quality name brand cotton or cotton blend shirts.